11.Route the Press Arm Cable (66) over a 3 1/2" Pulley (43). Attach the Pulley and a Cable Trap (47) to the Top Frame (12) with an M10 x 40mm Screw (97). Make sure that the Cable Trap is oriented to hold the Cable in the groove of the Pulley.
12.Route the Press Arm Cable (66) through the Top Cover (24) and over a 3 1/2" Pulley (43). Attach the Pulley and a Cable Trap (47) to the Top Frame (12) with an M10 x 40mm Screw (97).
Make sure that the Cable Trap is oriented to hold the Cable in the groove of the Pulley.
13.Use the wire in the Right Press Arm (8) to pull the Press Arm Cable (66) down through the Press Arm. Make sure that the Cable is routed around the pulleys above the Press Arm as shown in the inset drawing.
Hold a 4" Pulley (42) over the Press Arm Cable (66). Attach the Pulley inside the Swivel Arm (26) with an M10 x 50mm Button Bolt (88), two M10 Washers (105), two 16mm x 6mm Spacers (11), and an M10 Nylon Locknut (108).
14.Orient the Cable Cover (63) as shown and slide it onto the Press Arm Cable (66).
Insert the Press Arm Cable (66) into the Cable Coupler (64). Tighten four M6 x 10mm Set Screws (114) into the Cable Coupler to hold the Cable in place.
Slide the Cable Cover (63) over the Cable Coupler (64).
11 | 47 |
|
|
|
| 43 |
|
| |
|
|
|
| |
97 |
|
|
|
|
66 |
|
|
|
|
12 |
|
|
| |
12 |
|
|
|
|
|
|
| 24 |
|
47 | 43 | 12 |
|
|
97 |
|
|
|
|
66 |
|
|
|
|
13 |
|
|
|
|
66 |
|
|
|
|
|
| 8 |
|
|
88 | 105 |
|
|
|
11 |
| 11 | 108 | |
42 |
|
|
|
|
|
| 26 | 105 |
|
| 66 |
|
| |
|
|
|
| |
14 |
|
|
|
|
|
|
| 66 |
|
| 114 |
|
|
|
64 |
|
|
|
|
|
|
| 63 |
|
| 114 |
|
|
|
9
