ProForm PFSY6806.0 user manual Repeat this step on the other side of the Dip Arm

17.Attach the Seat (19) to the Seat Frame (4) with two M6 x 30mm Screws (87) and an M6 x 100mm Screw (85).

Set the Seat Frame (4) onto a set of posts on the Upright (3).

18.Attach the Bumper (36) to the Leg Developer (6) with an M4 x 19mm Self-tapping Screw (100).

Apply grease to the barrel of a 2.5" Bolt Set (86). Attach the Leg Lever (6) to the Seat Frame (4) with the Bolt Set. Make sure that the barrel of the Bolt Set is inserted through both sides of the bracket on the Front Leg. Do not over- tighten the Bolt Set; the Leg Lever must pivot easily.

19.Attach a Front and Rear Dip Cap (33, 34) around a Dip Handle (10) with two M3 x 32mm Self-tap- ping Screws (102).

Tighten a Dip Arm Knob (51) into the Dip Arm (5). Pull the Knob out as far as it will go and insert the Dip Handle (10) through a Dip Arm Bushing (35) and into the Dip Arm. Engage the Knob into the Dip Handle.

Repeat this step on the other side of the Dip Arm (5).

20.Attach an Arm Pad (21) and an Arm Pad Base (22) to the Dip Arm (5) with two M6 x 70mm Screws (93).

Repeat this step on the other side of the Dip Arm (5).

17
19
	4		3
85	87
18
	Bracket
86
Grease
	100
6		86	4
	36
19
		51	5
	102
10			35
33	34	102
20
21
22
5	93

11