General Features

Scanning Features

Scan Mode

Selects the scan operating mode for the scanner. Selections are:

Single — When the trigger is pulled, scanning is activated until five seconds have elapsed or a bar code has been read or the trigger is released

Triggerless — When the trigger is pulled, scanning is activated until any of the following occur:

-Active Scanning Time has expired

-a bar code has been read

-the trigger is pulled a second time

The Double Read Timeout feature gates double reads while in this mode.

Stand — No trigger pull is required to read a bar code while in this mode. Scanning is turned on automatically (auto-sense) when an item is placed in the scanner's field of view and is turned off again when a bar code is read or Active Scanning Time has expired. The Double Read Timeout feature gates double reads while in this mode. If the trigger is pulled, the scanner acts as if it is in single read mode.

Upon exiting Single Read mode while Stand Mode is enabled, the software will delay 2 seconds before beginning its auto-sense operation.

NOTE

Stand With Illumination — Same as the option above, except that illumination is on while in this mode.

2-12

PowerScan® 7000 Linear Imager

Page 22
Image 22
PSC 7000 manual Scanning Features, Scan Mode