Preparing Contour to use AirPlay with an Ethernet cable
1.Connect an Ethernet cable from the Ethernet port on the back of Contour to your router.
Typical Ethernet setup
2. Insert the connector of the mains
power adapter into the DC In socket on the rear of Contour.
18V DC
3. Plug in to the mains supply.
4.A network connection between your router and Contour will then be established automatically. When the red Status LED on the front has stopped flashing, Contour is in Standby.
5.Press Standby on Contour or the remote control until Contour has AirPlay selected as its input source. If the Status LED is steady white then AirPlay has been setup successfully. If the Status LED is flashing white, there is a problem with Contour’s network connection.
Note: See “Help” on page 24 for help with troubleshooting Contour network connectivity issues.
6.Contour is now set up to use AirPlay with a wired connection. No further configuration is required. See page 11.
10
