Q-Logic 2-8C manual Table B-16. Switch Operational Parameters

0			B – Command Line Interface
			Show Command
	Table B-16. Switch Operational Parameters (Continued)
	Parameter		Description
	NumberOfResets	Number of times the switch has been
		reset over its service life
	ReasonForLastReset	Action that caused the last reset
	SWImageVersion (1) - build date	Firmware image 1 version and build
		date. This image occupies position 1 in
		the flash memory.
	SWImageVersion (2) - build date	Firmware image 2 version and build
		date. This image occupies position 2 in
		the flash memory.
	ActiveImageVersion - build date	Firmware image and build date that is
		active. This is the firmware image that is
		currently running on the switch.
	PendingImageVersion - build date	Firmware image version and build date
		that is pending. This image will become
		active at the next reset or power cycle.
		The pending firmware points to either
		SWImageVersion (1) or (2).
	ActiveConfiguration	Name of the switch configuration that is
		in use.
	AdminState	Switch administrative state
	AdminModeActive	Admin session status
	BeaconOnStatus	Beacon status as set by the Set Beacon
		command.
	OperationalState	Switch operational state
	PrincipalSwitchRole	Principal switch status. True indicates
		that this switch is the principal switch.
	BoardTemp (1) - Degrees Celsius	Internal switch temperature at circuit
		board sensor 1
	BoardTemp (2) - Degrees Celsius	Internal switch temperature at circuit
		board sensor 2
	SwitchDiagnosticsStatus	Results of the power-on self test
	SwitchTemperatureStatus	Switch temperature status: normal,
		warning, failure

59042-06 A B-61