Q-Logic QLA2342, SB2A-16B manual Table B-10. Set Config Switch Parameters, Description

B – Command Line Interface	0
Set Config Command

switch

Initiates an editing session in which to change switch configuration settings. The system displays each parameter one line at a time and prompts you for a value. For each parameter, enter a new value or press the Enter key to accept the current value shown in brackets. Table B-10describes the Set Config Switch parameters.

Table B-10. Set Config Switch Parameters

Parameter	Description
AdminState	Switch administrative state: online,
	offline, or diagnostics. The default is
	Online.
BroadcastEnabled	Broadcast. Enables (True) or disables
	(False) forwarding of broadcast frames.
	The default is True.
InbandEnabled	Inband management. Enables (True) or
	disables (False) the ability to manage
	the switch over an ISL. The default is
	True.
FDMIEnabled	Fabric Device Monitoring Interface.
	Enables (True) or disables (False) the
	monitoring of target and initiator device
	information.
FDMIEntries	The number of device entries to
	maintain in the FDMI database. Enter a
	number from 0–1000. The default is
	1000.
DefaultDomainID	Default domain ID. The default is 1.
DomainIDLock	Prevents (True) or allows (False)
	dynamic reassignment of the
	domain ID. The default is False.
SymbolicName	Descriptive name for the switch. The
	name can be up to 32 characters
	excluding #, semicolon (;), and comma
	(,). The default is SANbox2.
R_A_TOV	Resource Allocation Timeout Value.
	The number of milliseconds the switch
	waits to allow two ports to allocate
	enough resources to establish a link.
	The default is 10000.

B-36 59021-09 A