Q-Logic SB2A-16B, QLA2342 Table B-14. System Configuration Settings Continued, Entry, Description

0			B – Command Line Interface
			Set Setup Command
	Table B-14. System Configuration Settings (Continued)
	Entry	Description
	Eth0NetworkMask	Ethernet subnet mask address.
	Eth0GatewayAddress	Ethernet IP address gateway.
	AdminTimeout	Amount of time in minutes the switch waits before
		terminating an idle Admin session. Zero (0)
		disables the time out threshold. The default is 30,
		the maximum is 1440.
	InactivityTimeout	Amount of time in minutes the switch waits before
		terminating an idle SANsurfer Switch Manager
		Web applet session. Zero (0) disables the time out
		threshold. The default is 0, the maximum is 1440.
	TempMonitoringWarning	Warning temperature threshold in °C above which
		a warning condition alarm is generated. The
		default is 40 °C.
	TempMonitoringFailure	Failure temperature threshold in °C above which a
		failure condition alarm is generated. The default is
		45 °C.
	TempFailurePortShutdown	Enables (True) or disables (False) the switch’s
		ability to place all ports down when the internal
		temperature exceeds the failure threshold. The
		default is False. If the temperature exceeds the
		failure threshold, correct the problem, then reset
		the switch to bring the ports back online.
	UserAuthentication	Enables (True) or disables (False) the enforcement
		of account names and passwords for SANsurfer
		Switch Manager. Enabling this parameter does not
		affect a logged in account until that account logs in
		again.The default is False.
	LocalLogEnabled	Enables (True) or disables (False) the saving of log
		information on the switch. The default is True.
	RemoteLogEnabled	Enables (True) or disables (False) the recording of
		the switch event log on a remote host that supports
		the syslog protocol. The default is False.
	RemoteLogHostAddress	The IP address of the host that will receive the
		switch event log information if remote logging is
		enabled. The default is 10.0.0.254.

59021-09 A B-51