Q-Logic SB2A-16B, QLA2342 manual Table B-12. Set Config Zoning Parameters, Description

0	B – Command Line Interface
	Set Config Command

zoning

Initiates an editing session in which to change switch zoning attributes. The system displays each parameter one line at a time and prompts you for a value. For each parameter, enter a new value or press the Enter key to accept the current value shown in brackets.

	Table B-12. Set Config Zoning Parameters
Parameter		Description
FC-SW-2		Available only when the FC-SW-2 Compliant parameter is
AutoSave		True, this parameter enables (True) or disables (False) the
		saving of changes to active zone set in the switch’s permanent
		memory. Refer to ”FC-SW-2 Compliant” on page B-37. The
		default is True.
		Disabling the Autosave parameter can be useful to prevent the
		propagation of zoning information when experimenting with
		different zoning schemes. However, leaving the Autosave
		parameter disabled can disrupt device configurations should a
		switch have to be reset. For this reason, the Autosave
		parameter should be enabled in a production environment.
Default Visibility		Enables (All) or disables (None) communication among the
		switch’s ports/devices and the fabric in the absence of an
		active zone set. The default is All.

59021-09 A B-39