Test Menu
The Test menu allows you to select the user controlled test modes. The “Quick Test” mode will perform a test of all of the key parameters of the UPS, including operation from the battery. The “Test To Low Bat” selection will place the UPS in the battery power mode, and run until the battery voltage drops to the Low Battery Warning point.
Test Menu
Menu Scroll
Select “scroll” to go to the various test choices.
Quick Test |
Menu Yes Scroll |
Testing |
Test to Low Bat |
Menu Yes |
Testing |
Menu |
Testing |
Perform the 10 second Quick Test.
Perform extended “Test to Low Battery”
Test to Low Battery - Pressing the YES button will run the load on the inverter until battery voltage drops to the low voltage battery warning point, or until the test is canceled by the user.
The test may be canceled at any time by pressing the “Cancel” button. Pressing the “Menu” button will move you to the SETUP menu, even if the test is still in progress. By repeatedly pressing the “Menu” button, you can move to the STATUS menu to monitor the progress of the test. Stepping through the status menu with the “Scroll” button will allow you to read the various values described previously in the STATUS menu. To terminate the test, use the “Menu” button to select the TEST menu. You will then be given the option to cancel the test. If an alarm condition occurs you will be transferred to the reporting display to determine the cause of the alarm.
21
