Installing the Charging Cradle | Radio Shack 43-3595 specs

Installation

∀ CAUTION ∀

You must use

!a Class 2 power source that supplies

9V DC and delivers at least 210 mA. Its center tip must be set to positive and its plug must fit the phone’s DC IN 9V jack. The supplied adapter meets these specifications. Using an adapter that does not meet these specifications could damage the phone or the adapter.

ON A DESKTOP

1.Plug one end of the supplied long modular cord into the TEL LINE jack on the bottom of the base.

2.Insert the supplied AC adapter’s barrel plug into the DC IN 9V jack on the bottom of the base and route the

adapter’s cord through the strain relief slot on the base.∀

3.Plug the other end of the modular cord into a modular phone line jack.

4.Plug the adapter into a standard AC outlet.

INSTALLING THE CHARGING CRADLE

1. Insert the supplied

	AC adapter’s
	barrel plug into the	DC IN 9V
	DC IN 9V jack on	DC IN 9V
	DC IN 9V jack on
	the back of the
	charger.
	2. Route the cord
	through the strain
	relief slot and plug
	the adapter into a
	standard AC
	outlet.

ON A WALL

PLATE OR WALL

To mount the main base directly on a wall, you need two screws (not supplied) with heads that fit into the keyhole slots on the base. Drill two holes 315/16 inches apart. Thread a screw into each hole, letting the heads extend about 1/8 inch.

8

Image 8

Radio Shack 43-3595 important safety instructions Installing the Charging Cradle, On a Wall Plate or Wall

Contents

MHz Cordless Telephone Introduction Introduction Information FCC Statement Surge Protection Important Safety Instructions Important Caller ID Information Installation Selecting a Location Installing the Charging Cradle On a Wall Plate or Wall CONNECTING/CHARGING the Battery Pack Lift the battery pack out of the compartment CHARGE/IN USE or Before USING, Register Extra Handset to Main Base Unit OWARNING o When to RE-REGISTER Handsets Call Transfer Feature To transfer a call to the second handset Operation Making and Receiving Calls Adjusting the Handset Ringer and Earpiece Volume Handset Ringer Tone VolumeEarpiece Volume Tone Dialing SWITCH-OVER Temporarily Mute RingerRedial Traveling OUT of Range Flash and Call Waiting Setting Menu OptionsChanging the Auto Talk Entering Your Area Code Cidcw Choosing the Dialing Mode Memory DialingStoring Phone Numbers and Names Dial Press CH/SEL. Store Number is displayed Memory 1 Stored Steps for Entering Names and Special Characters Memory Dialing from Standby Mode Memory Dialing from Talk ModeIf you make a mistake while entering a name Making Calls with Memory Dialing Chain Dialing Editing a Stored Name AND/OR Phone Number Erasing a Stored Name and Phone Number Yes Testing Stored Emergency NumbersONE-TOUCH Speed Dial Storing and Editing the Speed Dial Making Calls with the Speed DialDeleting the Speed Dial Delete Number When the Telephone Rings Caller ID Viewing the Caller ID Message List Deleting Information from the Caller ID List Deleting a Caller ID Message Deleting all Caller ID Names/ NumbersAll? or Delete Yes or No Long Distance Calls and Area Code Setting/Cancellation Using the Caller ID ListCalling a Party from the Caller ID List Dial Edit Changing the Digital Security Code Installing the Optional Beltclip Headset InstallationAdditional Information To attach the beltclip Troubleshooting Problem Solution Unavailable message is Service and Repair CarePage Page Page RadioShack Corporation