Additional Information, Headset Installation | Radio Shack 43-3595

security code is set. Otherwise, return to step 1 and try again.

ADDITIONAL

INFORMATION

INSTALLING THE OPTIONAL BELTCLIP

To attach the beltclip

Insert the beltclip into the holes on each side of the handset. Press down until it clicks.

To remove the beltclip

Pull both sides of the beltclip to release the tabs from the holes.

HEADSET INSTALLATION

You can connect an optional headset with a 3/32-inch (2.5-mm) plug. Contact RadioShack for a suitable headset.

To connect the headset, open the rubber cover on the side of the handset. Then insert the headset’s plug into the jack.Ô

When you ﬁnish using the headset, disconnect it from the handset and close the rubber cover to protect the jack.

Ô NOTES Ô

•If you place the handset on the cradle to recharge it while the headset is connected, be sure the handset seats properly.

•You can use a handset holder (available from your local RadioShack store) to hang the handset on your belt for greater convenience when using a headset.

Additional Information

33

Image 33

Radio Shack 43-3595 Additional Information, To attach the beltclip, To remove the beltclip, Headset Installation

Contents

MHz Cordless Telephone Introduction Introduction FCC Statement Information Surge Protection Important Safety Instructions Important Caller ID Information Selecting a Location Installation On a Wall Plate or Wall Installing the Charging Cradle Lift the battery pack out of the compartment CONNECTING/CHARGING the Battery Pack CHARGE/IN USE or OWARNING o Before USING, Register Extra Handset to Main Base Unit When to RE-REGISTER Handsets To transfer a call to the second handset Call Transfer Feature Making and Receiving Calls Operation Handset Ringer Tone Volume Earpiece VolumeAdjusting the Handset Ringer and Earpiece Volume Temporarily Mute Ringer Tone Dialing SWITCH-OVERRedial Traveling OUT of Range Setting Menu Options Changing the Auto TalkFlash and Call Waiting Cidcw Entering Your Area Code Memory Dialing Choosing the Dialing ModeStoring Phone Numbers and Names Dial Press CH/SEL. Store Number is displayed Memory 1 Stored Steps for Entering Names and Special Characters Memory Dialing from Talk Mode Memory Dialing from Standby ModeIf you make a mistake while entering a name Making Calls with Memory Dialing Editing a Stored Name AND/OR Phone Number Chain Dialing Erasing a Stored Name and Phone Number Testing Stored Emergency Numbers ONE-TOUCH Speed DialYes Making Calls with the Speed Dial Storing and Editing the Speed DialDeleting the Speed Dial Delete Number Caller ID When the Telephone Rings Deleting Information from the Caller ID List Viewing the Caller ID Message List Deleting all Caller ID Names/ Numbers Deleting a Caller ID MessageAll? or Delete Yes or No Using the Caller ID List Long Distance Calls and Area Code Setting/CancellationCalling a Party from the Caller ID List Dial Edit Changing the Digital Security Code Headset Installation Installing the Optional BeltclipAdditional Information To attach the beltclip Problem Solution Troubleshooting Unavailable message is Care Service and RepairPage Page Page RadioShack Corporation