Radio Shack ET-1102 owner manual Charge Indicator

43-1102.fm Page 10 Tuesday, August 17, 1999 4:37 PM

1.Press down and slide off the battery pack compartment cover as shown.

2.Unfasten the plastic retainer strap and lift the battery pack out of the compartment.

3.Plug the battery pack’s connector in- to the socket in the compartment (the connector fits only one way), then replace the battery pack and fasten the retainer strap.

4.Replace the cover.

To charge the battery pack, place the handset either faceup or facedown on the base. The CHARGE indicator on the base lights and Total:00 appears on the handset display.

CHARGE Indicator

Recharge the battery pack when Low Battery flashes on the display.

10

Important: Be sure the battery pack is properly connected before you try to charge it. The CHARGE indicator lights when the handset is on the base, even if the battery pack is not connected.

Notes:

•When you first use the phone after charging or recharging the battery pack, the phone might not work and you might hear an error tone when you press TALK. If this happens, re- turn the handset to the base for about 5 seconds. This resets the se- curity access-protection code.

•If the base loses power for 30 min- utes while the handset is away from it, the security access-protection code might be lost. To reset the code, return the handset to the base for about 5 seconds.

The handset does not lose its secu- rity access-protection code even if the battery pack is completely dis- charged.

•Using a pencil eraser, clean the charging contacts on the handset and the base about once a month.