Programming Guide
11.4 Device Setup
11.4.1 Temperature Calculation
U=C | unit for the temperature value |
E=0.950 | Emissivity setting (Caution: according to the settings |
| for “ES”, see section 11.4.2 Emissivity Setting and |
| Alarm Setpoints on page 70.) |
XG=1.000 | Setting for transmission |
For the calculation of the temperature value, it is possible to set an offset (relative number to be added to the temperature value), and a gain value.
DG=1.0000
DO=0
In case the ambient temperature is not requested by the internal head temperature, you must set the ambient temperature values as follows:
A=250.0
AC=1
11.4.2 Emissivity Setting and Alarm Set points
The device allows three choices for the emissivity setting and two for the alarm output setting.
ES | Selection of the emissivity setting. |
ES=1 | Emissivity set by a constant number according to the |
| „E“ command |
ES=E | Emissivity set by a voltage on FTC1 (analog input) |
ES=D | Emissivity set by the entries in a table (selected by |
| digital inputs FTC1 – FTC 3) |
?CE | asks for the emissivity value that is actually used for |
| temperature calculation |
70 | MI |
