Mounting the Mast
6.Install the togglers:
a.Carefully fold one end of the metal channel along the plastic straps. Hold the metal channel flat against the plastic straps and slide it through the hole.
b.Pull the ring so the metal channel rests flush behind the wall. Hold the ring tight and slide the plastic cap along the straps until the cap is flush with the wall.
Wall | Wall |
| |
Metal channel |
|
| Plastic cap |
| Metal |
| chann |
| Fold in |
| Ring |
Step 6a: Slide the metal channel | Step 6b: Make sure the plastic cap is |
through the hole. | flush with the wall. |
c.Push the straps
Step 6c: Snap off straps flush with the wall.
d.Repeat for all eight holes.
7.Use a 7/16" wrench to loosen the nuts on the mounting foot so you can rotate the mast to access both of the center mounting holes.
8.Hold the mounting foot over the holes so the top part of the mast will rotate and point straight up. For the final mounting, you should use a carpenter’s level or a circular level to assure that the mast is plumb and level.
No | Yes |
Step 8: Make sure that the top of the mast will point straight up.
9.Place washers on each of eight #20, 1/4" x 3" machine screws and attach the mounting foot to the wall. Securely tighten the screws.
10.Go on to the next section, “Final Installation,” to complete the installation process.
24 | Chapter 2 |
