RCA 15407690 manual LNB Hardware

Final Installation

2.If your cables are not marked, you may want to mark each cable with masking tape so that you know which cables to attach to each LNB, and subsequently to the multiswitch.

3.Separate the messenger (ground) wire from the coaxial cables. Push only the coaxial cable through the bottom of the mast and out the top. Pull about 2 feet of cable out of the top. Loop the cable and push it through the LNB support arm as shown below.

4.Place some silicone grease on the LNB connector and connect the ends of the coaxial cables to the LNB connection jacks for Antenna A (101° satellite).

Step 2: Route the cables	Steps 3-4:Connect the coaxial
through the mast.	cables to the LNB.

5.Insert the end of the LNB into the end of the LNB adapter (push any extra coaxial cable back through the support arm).

6.Secure each the LNB by inserting a #8 hex nut in the top of the adapter and screwing in a phillips head screw through the bottom of the adapter.

LNB Hardware

#8 x 1” Phillips Head Screw

(LNB & Adapter Mounting)

#8 Insert Nut

(LNB & Adapter Mounting)

Steps 5-6:Secure the LNB to adapter.

30 Chapter 3