Mounting the Mast
Mounting the Mast on a Hollow or Cinder Block Wall
DANGER
AVOID Power Lines!
Materials Needed
8 1/4" hollow wall togglers
8 #20, 1/4 x 3" machine screw
8 5/16" washers
Tools Needed
•Electric drill with 1/2" masonry bit
•Carpenter's level
•Screwdriver
•7/16" wrench
•Pencil
When following these instructions, take extreme care to avoid contact with overhead power lines, electric lights, and power circuits. Contact with power lines, electric lights, or power circuits may be fatal. It is recommended that the DIRECTV PLUS™ dish be located more than 20 feet from overhead power lines.
IMPORTANT Consideration
•Do NOT mount the DIRECTV PLUS™ dish under an eave or overhang that may block or partially shadow the DIRECTV PLUS™ dish.
Mounting Instructions
1.When installing togglers in cinder blocks, it is important to position them in the core of the block. To position the foot on the wall, measure 71/2" from one edge of the block and mark the center of the block.
2.Center the mounting foot on the mark you made.
3.Level the center line of the mounting foot using a bubble level.
4.Mark the eight outside corner holes.
LEVEL
NOT LEVEL
5.Remove the mounting foot. Drill a 1/2" hole at the marked locations.
Continued on next page
Chapter 2 | 23 |
