Installing an Expansion module, Push up to lock | BT BT Versatility

BT Versatility

Installation and maintenance Manual

Installing an Expansion module

Install the Backplane as described on page 12.

Install the MDF in the first free left-hand slot on the backplane.

Lock the MDF in place by pushing the lock bar upward using a screwdriver.

Push up to lock

Lift the MDF cover and install the module.

14

Image 15

BT BT Versatility manual Installing an Expansion module, Push up to lock

Contents

BT Versatility Contents General overview Introduction Safety Precautions during installation and system upgrades Electrostatic precaution ESPLightning and surge voltage protection BT Versatility Pro. PlusIncludes System, VM, 1M,2V8 Maintenance items Installation checklist Wall mount bracket Installing the Central Control UnitCCU LocationCCU Mounting the CCU CCU Mounting bracket clearances CCU Mounting BracketCCU Bracket + Backplane Bracket 300mm min Module location Modules located in the CCU Installing the Backplane wall bracket System ExpansionMounting the CCU with two brackets Mounting screw hole Mounting the Backplane Expansion Modules Push up to lock Installing an Expansion module Remove the cover Locate the Module First network module Installing the Analogue Module in the CCUAnalogue line module Analogue Module To Locate the Analogue Module in the Ports Module Installing the Basic Rate Isdn Module in the CCU Basic Rate Isdn expansion moduleDigital Line Module Isdn First network module Second Module. Can be external T or internal S To Locate the Digital Line Module Isdn 2 in the Ports module System Isdn settings T0 interface terminationS0 interface termination Back up Voice Module voice messages and Greetings Voicemail module Primary Rate Interface Availability TBC Battery charger connector on the PSU Connecting the battery backup unit to the system Led Indicators Connecting the Battery V16 Featurephone connections underside of phone Featurephone V8 Featurephone connections underside of phone Position at 35 degrees Attaching the Featurephone desk plinth V8 Expansion console Feature phone with consoleTo connect the V16 Console to a Featurephone V16 only V16 expansion console Clip, Plinth and installation of the V16 expansion console Line cord rails Wall-mounting a Featurephone Door Intercom Wall hook when the V8/V16 is wall mounted Connecting the extensions Cabling the unitCabling Break outs Speech Pin Data Connecting a MOH Music On Hold Module CCU connectionsDoor Intercom Doorstrike MOH Module contains Connecting a PA public Address amplifierConnecting a PC or Printer to the Serial Port Ports Module MDF Connections Internet Module MDF Connections Cable limitations Options Module MDF ConnectionsCentral Bell External Extension Installing an additional Network Analogue or Isdn module Installing additional modulesExpanding an Existing system Hot Swapping faulty modules Maintenance procedures Replacing a faulty Module MDF Replacing the 008 extension board Replacing Faulty PCBs Replacing the CCU Control PCB Power supply unit spare fuse Spare Fuse Replacing the Power Supply Unit Replacing the CCU MDF Power fail AnalogueLine position Power up and test Switch onCommissioning Programming Equipped exchange linesIncoming ringing Call Barring Internet Module Programming Installation Wizard Adsl Isdn Recommendations for customer training Troubleshooting 230 ± 10% V 50 Hz Technical specification LAN Full remote support from a BT Maintenance Centre Index Offices Worldwide