Door Intercom | BT BT Versatility instruction

BT Versatility

Installation and maintenance Manual

Wall hook when the V8/V16 is in a 20 degrees or 35 degrees position

Wall hook when the V8/V16 is wall mounted.

Door Intercom

The door intercom is connected to extension 23, the fourth extension on the CCU.

Door intercom

bracket

Mounting screw

Connect the single pair from the door intercom to the AB connections on extension 23.

The system must be programmed to recognise the Door intercom. Refer to the BT Versatility Owner's manual for programming details.

30

Image 31

BT BT Versatility manual Door Intercom, Wall hook when the V8/V16 is wall mounted

Contents

BT Versatility Contents General overview Introduction Electrostatic precaution ESP Safety Precautions during installation and system upgradesLightning and surge voltage protection BT Versatility Pro. PlusIncludes System, VM, 1M,2V8 Maintenance items Installation checklist Wall mount bracket Installing the Central Control UnitCCU LocationCCU Mounting the CCU CCU Mounting Bracket CCU Mounting bracket clearancesCCU Bracket + Backplane Bracket 300mm min Module location Modules located in the CCU System Expansion Installing the Backplane wall bracketMounting the CCU with two brackets Mounting screw hole Mounting the Backplane Expansion Modules Push up to lock Installing an Expansion module Remove the cover Locate the Module First network module Installing the Analogue Module in the CCUAnalogue line module Analogue Module To Locate the Analogue Module in the Ports Module Basic Rate Isdn expansion module Installing the Basic Rate Isdn Module in the CCUDigital Line Module Isdn First network module Second Module. Can be external T or internal S To Locate the Digital Line Module Isdn 2 in the Ports module T0 interface termination System Isdn settingsS0 interface termination Back up Voice Module voice messages and Greetings Voicemail module Primary Rate Interface Availability TBC Battery charger connector on the PSU Connecting the battery backup unit to the system Led Indicators Connecting the Battery V16 Featurephone connections underside of phone Featurephone V8 Featurephone connections underside of phone Position at 35 degrees Attaching the Featurephone desk plinth V8 Expansion console Feature phone with consoleTo connect the V16 Console to a Featurephone V16 only V16 expansion console Clip, Plinth and installation of the V16 expansion console Line cord rails Wall-mounting a Featurephone Door Intercom Wall hook when the V8/V16 is wall mounted Cabling the unit Connecting the extensionsCabling Break outs Speech Pin Data CCU connections Connecting a MOH Music On Hold ModuleDoor Intercom Doorstrike MOH Module contains Connecting a PA public Address amplifierConnecting a PC or Printer to the Serial Port Ports Module MDF Connections Internet Module MDF Connections Cable limitations Options Module MDF ConnectionsCentral Bell External Extension Installing additional modules Installing an additional Network Analogue or Isdn moduleExpanding an Existing system Hot Swapping faulty modules Maintenance procedures Replacing a faulty Module MDF Replacing the 008 extension board Replacing Faulty PCBs Replacing the CCU Control PCB Power supply unit spare fuse Spare Fuse Replacing the Power Supply Unit Replacing the CCU MDF Analogue Power failLine position Switch on Power up and testCommissioning Equipped exchange lines ProgrammingIncoming ringing Call Barring Internet Module Programming Installation Wizard Adsl Isdn Recommendations for customer training Troubleshooting 230 ± 10% V 50 Hz Technical specification LAN Full remote support from a BT Maintenance Centre Index Offices Worldwide