Connecting the Battery, Led Indicators | BT BT Versatility guide

BT Versatility

Installation and Maintenance Manual

Connecting the Battery

Ensure the battery switch on the BBU unit is turned off.

•This switch does not turn off the mains supply. The mains is disconnected by unplugging the mains cord

•Insert the battery into the battery cavity in the CCU

•Connect the cables from the battery charger to the battery ensuring that the cables are connected correctly. Red cable to Red battery terminal, black cable to Black battery terminal

•Turn the battery charger switch on.

•Reconnect the mains.

Led Indicators

A status LED on the BBU is provided.

•GREEN indicates the unit is running from mains power and the battery is charging or fully charged.

•ORANGE indicates the unit is running off the Battery

•RED indicates that the battery is discharged

•Flashing RED indicates the battery is disconnected and the switch is running from the mains

23

Image 24

BT BT Versatility manual Connecting the Battery, Led Indicators

Contents

BT Versatility Contents Introduction General overview Safety Precautions during installation and system upgrades Electrostatic precaution ESPLightning and surge voltage protection BT Versatility Pro. PlusIncludes System, VM, 1M,2V8 Maintenance items Installation checklist Installing the Central Control Unit CCU LocationCCUMounting the CCU Wall mount bracket CCU Mounting bracket clearances CCU Mounting BracketCCU Bracket + Backplane Bracket 300mm min Modules located in the CCU Module location Installing the Backplane wall bracket System ExpansionMounting the CCU with two brackets Mounting the Backplane Mounting screw hole Expansion Modules Installing an Expansion module Push up to lock Installing the Analogue Module in the CCU Analogue line moduleAnalogue Module Remove the cover Locate the Module First network module To Locate the Analogue Module in the Ports Module Installing the Basic Rate Isdn Module in the CCU Basic Rate Isdn expansion moduleDigital Line Module Isdn First network module To Locate the Digital Line Module Isdn 2 in the Ports module Second Module. Can be external T or internal S System Isdn settings T0 interface terminationS0 interface termination Voicemail module Back up Voice Module voice messages and Greetings Primary Rate Interface Availability TBC Connecting the battery backup unit to the system Battery charger connector on the PSU Connecting the Battery Led Indicators Featurephone V16 Featurephone connections underside of phone V8 Featurephone connections underside of phone Attaching the Featurephone desk plinth V8 Position at 35 degrees Feature phone with console To connect the V16 Console to a Featurephone V16 onlyV16 expansion console Expansion console Clip, Plinth and installation of the V16 expansion console Wall-mounting a Featurephone Line cord rails Wall hook when the V8/V16 is wall mounted Door Intercom Connecting the extensions Cabling the unitCabling Break outs Speech Pin Data Connecting a MOH Music On Hold Module CCU connectionsDoor Intercom Doorstrike Connecting a PA public Address amplifier Connecting a PC or Printer to the Serial PortPorts Module MDF Connections MOH Module contains Internet Module MDF Connections Options Module MDF Connections Central BellExternal Extension Cable limitations Installing an additional Network Analogue or Isdn module Installing additional modulesExpanding an Existing system Maintenance procedures Hot Swapping faulty modules Replacing a faulty Module MDF Replacing Faulty PCBs Replacing the 008 extension board Replacing the CCU Control PCB Power supply unit spare fuse Replacing the Power Supply Unit Spare Fuse Replacing the CCU MDF Power fail AnalogueLine position Power up and test Switch onCommissioning Programming Equipped exchange linesIncoming ringing Call Barring Installation Wizard Internet Module Programming Adsl Isdn Recommendations for customer training Troubleshooting Technical specification 230 ± 10% V 50 Hz LAN Full remote support from a BT Maintenance Centre Index Offices Worldwide