Programming the Telephone
Auto Answer Intercom (applicable for base and handset)
If it is set to on, this handset or base will auto answer the intercom call when it receives an intercom call.
From the Phone Setting Menu:
1.Press the VOL (- or +) button to scroll to Auto Answer Int.
2.Press SELECT soft key. Use the VOL (- or +) button to scroll to your selection. The default setting is Off.
3.Press SELECT soft key to save your selection and “Saved” shows in the display.
Dial Mode (only applicable for base)
The Dial Mode of Line 1 and Line 2 can be set separately.
From the Phone Setting Menu:
1.Press the VOL (- or +) button to scroll to the Dial mode.
2.Press SELECT soft key.
3.Use the VOL (- or +) button to select Tone or Pulse and use the DIR or CID button to select L1 or L2.
4.Press SELECT soft key to save your selection and “Saved” shows in the display.
NOTE: The Dial mode only can be set in the base menu.
Area Code (only applicable for base)
The telephone uses the
From the Phone setting Menu:
1.Press the VOL (- or +) button to scroll to the Area code.
2.Press SELECT soft key.
3.Use the
4.Press SAVE soft key to save your selection and “Saved” shows in the display.
Registration (only applicable to handset)
A cordless handset will not operate until it is registered to the base. During the registration process, keep the handset near the base. Up to 10 cordless handsets can be registered to one base.
NOTE: If a handset has not been registered to the base, then the display will show “PRESS “REG” TO INITIATE REGISTRATION” once the handset has been activated. Press the REG soft key to start the registration.
From the Phone Setting Menu:
1.Press the VOL (- or +) button to scroll to Registration.
2.Press SELECT soft key and you may program the following items: Register and Remove handset.
16
