Playback

Playback on a TV without Audio/Video Inputs

To connect your camcorder to a TV without audio/video inputs, you will need an optional CRF800 output adapter and an optional coaxial RF cable, such as VH82 or VH90 shown on page 43. If your TV has AUDIO and VIDEO IN jacks (or is connected to a VCR), refer to pages 38-39.

Optional

OR

 

RF Coaxial

 

Cable

 

(such as VH82

Optional

or VH90)

Transformer

 

 

(Such as VH54)

CHANNEL

 

4CH/3CH

 

Switch

 

VHF

IN

FROM

ANT

VHF

Back of TV

Back of TV

 

 

VHF Antenna

 

 

OR

Optional

 

 

CRF800 RF

Optional 300-75 Ohm

VHF Antenna

Output Adapter

Transformer

 

 

Installation

1.Disconnect the VHF antenna from your TV. Connect the antenna to the connector on the RF output adapter as shown above if you are going to leave the adapter connected to the TV.

Note: If your VHF antenna is the flat twin-lead type attached by two screws, you will also need an optional 300/75 ohm transformer.

2.Attach one end of the optional coaxial RF cable to the other connector on

the adapter, and attach the other end to the VHF input on your TV as shown.

Note: If your TV has 300 ohm screw terminals, you will need a 75/300 ohm transformer, such as VH54, shown on page 43.

3.Attach the RF output adapter’s plug to the A, RF OUT, and V jacks located under the small cover on the side of the camcorder.

40

Page 42
Image 42
RCA ProV600 manual Playback on a TV without Audio/Video Inputs, Back of TV VHF Antenna