F33
F34
English
11. Maintenance of Saw Chain and Guide Bar
Make sure every cutter has the same length and edge angles as illustrated. (F33)
(1)Cutter length
(2)Filing angle
(3)Side plate angle
(4)Top plate cutting angle
■GUIDE BAR
•Reverse the bar occasionally to prevent partial wear.
•The bar rail should always be a square. Check for wear of the bar rail. Apply a ruler to the bar and the outside of a cutter. If a gap is observed between them, the rail is normal. Otherwise, the bar rail is worn. Such a bar needs to be corrected or replaced. (F34)
(1) | Ruler |
|
|
|
(2) | Gap |
|
|
|
(3) | No gap |
|
|
|
(4) | Chain tilts |
|
|
|
|
|
|
| |
|
| RedMax Part Number |
| |
| Bar Size | Guide Bar | Saw Chain |
|
| 16” (45cm) | G0021 |
|
|
For replacement use only above bars and chains or the following:
OREGON BAR
16 inch DUBLE GUARD™ Pro bar Mount code #A195.
OREGON CHAIN
33SL
50
