RedMax G5000AVS manual Symbols on the machine, Emission Control, Important Engine Information

4. Symbols on the machine

	For safe operation and maintenance,
	symbols are carved in relief on the
	machine.
	According to these indications, please
	be careful not to make any mistake.
(a)	(a) The port to refuel “MIX GASOLINE”
	Position: Fuel cap
	(b) The port to top up chain oil
(b)
	Position: Oil cap
(c)	(c) Setting the switch to the “ ” position, the engine
	starts.
	Setting the switch to the “O” position, the engine
	stops immediately.
	Position: Rear-left of the unit
	(d) Starting the engine. If you pull out the choke knob
(d)
	(at the back-right of the rear handle) to the point of
	the arrow, you can set the starting mode as follows:
	•First-stage position – starting mode when the
	engine is warm. (warm start)
	•Second-stage position – starting mode when the
	engine is cold. (cold start)
	Position: Upper-right of the aircleaner cover

(e)	(e) The screw under the “H” stamp is The High-speed
	adjustment screw.
	The screw under the “L” stamp is The Slow-speed
	adjustment screw.
	The screw at the left of the “T” stamp is the Idle
	adjustment screw.
	Position: Left side of the rear handle
(f)	(f) Shows the directions that the chain brake is
	released (white arrow) and activated (black arrow).
	Position: Front of the chain cover
	■ EMISSION CONTROL
	An emission control label is located on the engine.
	IMPORTANT ENGINE INFORMATION
	THIS ENGINE CONFORMS TO U.S. EPA
	PH1 FOR SMALL OFF-ROAD ENGINES.
	ENGINE FAMILY : 6KZXS. 0494LM ; EM
	ENGINE DISPLACEMENT : 49cm3
	REFER TO OWNER’S MANUMAL FOR MAINTE-
	NANCE SPECIFICATIONS AND ADJUSTMENTS.
	MANUFACTURED:
	RedMax Made in Japan

8