RedMax G5000AVS manual Operation, F8 F9 F10, English

F8

F9

F10

English

8. Operation

5.While holding the saw unit securely on the ground, pull the starter rope vigorously. (F8)

WARNING

Do not start the engine while hanging the chain saw with a hand. The saw chain may touch your body. It's very dangerous.

6.When engine has ignited first, push in the choke knob and pull the starter again to start the engine.

7.Allow the engine to warm up with the throttle lever pulled slightly.

WARNING

Keep clear of the saw chain as it will start rotating upon starting of engine.

■CHECKING OIL SUPPLY

WARNING

Make sure to set up the bar and the chain when checking the oil supply.

If not, the rotating parts may be exposed. It is very dangerous.

After starting the engine, run the chain at medium speed and see if chain oil is scattered oft as shown in the figure. (F9)

(1) Chain oil

The chain oil flow can be changed by inserting a screwdriver in the hole on bottom of the clutch side. Adjust according to your work conditions. (F10)

(1) Adjuster

NOTE

The oil tank should become nearly empty by the time fuel is used up. Be sure to refill the oil tank every time when refueling the saw.

28