INSTALLATION
VERTICAL TERMINATION WITH
THE APPLIANCE MUST NOT BE CONNECTED TO A CHIMNEY FLUE SERVING
A SEPARATE SOLID FUEL BURNING APPLIANCE.
This appliance is designed to be attached to two 3" (76mm)
Masonry chimneys may take various contours which the fl exible liner will accommodate. However, keep the flexible liner as straight as possible, avoid unnecessary bending.
The Air Intake pipe must be attached to the inlet air collar of the termination cap.
Required Parts:
Part # | Description | |||
3" Flex - 35 ft. | ||||
F37 |
| |||
| which contains the following: | |||
| ||||
| Outer Pipe | |||
| Inner Pipe Adapter | |||
Approved Caps | ||||
980 | Vertical Termination Cap | |||
923GK | 3" |
|
|
|
| ||||
| ||||
| with fl ashing |
GAS CONNECTION
The gas connection is a 1/2" NPT Male Thread. Copper can be used or other con- nections approved by AG 604.
When using copper or fl ex connectors use only approved fi ttings. Always provide a union so that gas lines can be easily disconnected for burner and/or valve servicing. Flare nuts for copper lines are usually considered to meet this requirement.
Important:Always check for gas leaks with a soap and water solution or gas leak detector. Do not use open flame for leak testing.
Note: Prior to any pressure testing of the gas supply piping system that exceeds test pressures of
3.45kPa, this appliance must be disconnected from the pip- ing system. If test pressures equal to or less than 3.45 kPa are used then this appliance must be isolated from the piping system by closing its individual manual
System Data - F37
| Burner Inlet Orifice Sizes: |
|
| |
| NG LPG |
|
| |
| Burner | #37 | #52 |
|
|
|
|
|
|
| Max. Input Rating | 31.7 mj |
|
|
| Min. Input Rating | 16 mj |
|
|
|
|
|
|
|
| Supply Pressure |
|
|
|
| NG | min. 1.13kPa |
| |
| LPG | min. 2.75kPa |
| |
|
|
|
|
|
| Manifold Pressure |
|
|
|
| NG | .89 kPa |
|
|
| LPG | 2.55 kPa |
|
|
12 | F37 Regency® Rear Flued Room Sealed Freestanding Gas Heater |