INSTALLATION
OPTIONAL
REMOTE CONTROL
Use the Regency® Remote Control Kit ap- proved for this unit. Use of other systems may void your warranty.
The remote control kit comes with a hand held transmitter, a receiver and a wall mounting plate.
1)Choose a convenient location on the wall to install the receiver and the receptacle box (protection from extreme heat is very important). Run wires from the fi replace to that location, use Thermostat Wire Table.
2)Connect the wires as per the wiring diagram above.
CAUTION
Do not connect the millivolt remote
control wires to the 240V wires.
3)Install 3 AAA alkaline batteries in transmitter and 4 AA alkaline batteries in the receiver. Install the receiver and its cover in the wall. Switch the remote receiver to "remote" mode. The remote control is now ready for operation.
Thermostat Wire Table
Recommended Maximum Lead Length
Thermostat
Wire Size | Max. Length | |
14 GA. | 15.24 | m |
16 GA. | 9.75 | m |
18 GA. | 6.10 | m |
20 GA. | 3.66 | m |
22 GA. | 2.71 | m |
FINAL CHECK
Before leaving this unit with the customer, the installer must ensure that the appliance is fi ring correctly. This includes:
1)Clocking the appliance to ensure the cor- rect firing rate (rate noted on label) at 15 minutes.
2)Ifrequired,adjustingtheprimaryairtoensure that the fl ame does not carbon. First allow the unit to burn for 15 min. to stabilize.
CAUTION
Any alteration to the product that causes sooting or carboning that results in damage to the exterior facia is not the responsibility of the manufacturer.
This heater does not require a 240V A.C. supply for the gas control to operate.A240VA.C. power supply is needed for the fan/blower operation.
WIRING
Caution: Ensure that the wires do not touch any hot surfaces and are away from sharp edges.
CAUTION: Label all wires prior to dis- connection when servicing controls. Wiring errors can cause improper and dangerous operation.
WARNING: Electrical Grounding Instructions
This appliance is equipped with a three pronged (grounding) plug for your protection against shock hazard and should be plugged directly into a properly grounded
F37 Regency® Rear Flued Room Sealed Freestanding Gas Heater | 17 |