MAINTENANCE
LATCH ADJUSTMENT
The door latch may require adjustment as the door gasket material compresses after a few
fires and after glass replacement. Turn the handle on the adjustable catch to tighten or loosen the latch.
GLASS REPLACEMENT
Your Regency® stove is supplied with high tem- perature, 5 mm Neoceram ceramic glass that will withstand the highest heat that your unit will produce. In the event that you break your glass, purchase your replacement from an authorized Regency®
Never operate your unit with broken glass.
WARNING: Do not operate appli- ance with the glass front removed, cracked or broken. Replacement of the glass should be done by a licensed or qualified service per- son.
MITRED DOOR
Removing Glass:
Note: Wearing gloves will protect your hands while handling glass.
1)Remove the door from the unit and place on a soft surface to prevent scratching.
2)Pull out the door gasket.
3)Remove the 24 nuts holding the glass retainers in place. Do not remove the nuts underneath the retainers.
4)Remove the door catch plate.
5)Remove glass retainers on sides first (3 each side) then remove two center retainers.
Note: Center glass retainers are glued to center glass.
6)Remove glass from extrusions. When re- moving center glass, leave white insulation in place.
Installing Glass
1)Install both center and side glass onto extrusions as per diagram.
2)Place glass assembly into door frame.
3)Install retainers by placing 1 drop of glue where previously glued and put in place.
4)Install side retainers.
5)Install door catch plate.
6)Install the 24 nuts loosely, do not tighten yet.
7)Tighten side panels nuts using the following procedure:
a.tighten top & bottom outside corner nuts (2)
b.tighten inside nuts (3)
c.tighten top & bottom inside corners
(2)
8)Tighten the 10 nuts on center glass re- tainer.
9)Repeat step 7 for other side panel.
10)Replace new gasket by gluing it in place.
11)Install door onto stove and check the seal.
PANEL DOOR
1)Remove the door from the unit and place on a soft surface to prevent scratching.
2)Pull out the door gasket.
3)Remove the nuts holding the glass retainers in place.
4)Remove the glass retainers (sides, top and bottom) and the door catch plate.
5)Replace the glass. The glass must have gasketing around it.
6)Reverse the previous steps, replace the retainers and fasten with the nuts but do not overtighten, as this can break the glass. Note: the door catch plate fi ts on top of the left side retainer.
7)Put gasket glue on the retainers, but do not put glue on the screws. Replace the door gasket, the two ends butt tight together on the bottom edge of the door.
8)Replace door on the stove and check the seal.
F37 Regency® Rear Flued Room Sealed Freestanding Gas Heater | 21 |
