INSTALLATION
AERATION
ADJUSTMENT
The burner aeration is factory set but may need adjusting due to either the local gas supply, air supply or altitude.
NG: 10mm open
LPG: 10mm open
The aeration adjustment gears are located on the right side of the burner box and can be ac- cessed from the side or from the front when the louvres are removed.
LOG SET
INSTALLATION
Read the instructions below carefully and refer to the diagrams. If logs are broken do not use the unit until they are replaced. Broken logs can interfere with the pilot operation.
The gas log kit contains the following:
a)
b)
c)
d)
e)
f)
g)
h) | Embers | |
i) | Lava |
Note: Install Optional Brick Panels prior to installing logs.
3)Place Rear Log
A)02-65
Pins on Rear Log Support
4)Place the Middle Left Log
B)02-56
To adjust the aeration: use the allen key to turn the turning gear which will adjust the air shutter. Open the air shutter for a blue flame or close it for a yellower fl ame. This adjustment is performed by an authorized installer. The factory setting should be suffi cient for most installations.
Clockwise to open,
Caution: Carbon will be produced if the air shutter is closed too much.
Note: Any damage due to carboning result- ing from improperly setting the aera- tion controls is NOT covered under warranty.
The "02" refer numbers (i.e. 02-65) are
molded into the rear of each log.
1)Carefully remove the logs from the box and unwrap them. The logs are fragile, handle with care - do not force into position.
2)Sprinkle the embers on the left and right sides of the fi rebox base.
EmbersEmbers
5)Sprinkle some lava rock just in front of B)
lava rock
6)Place Front Left Log
C)02-44
14 | F37 Regency® Rear Flued Room Sealed Freestanding Gas Heater |
