OPERATING INSTRUCTIONS
MATCHING REMOTE
HANDSET & CONTROL
BOX ID CODE
The Remote Control Handset has a set of unique ID codes that is
To ensure the remote control is matched to the receiver correctly, please follow the steps below:
1.Install the 2 x AAA alkaline batteries into the Remote Control.
2.Unplug and
3.Press and hold the PROG and FAN buttons simultaneously for up to 20 seconds. During this time, the remote will display LC while it is transmitting codes to the receiver.
OPERATING
INSTRUCTIONS
1)Read and understand these instructions before operating this appliance.
2)Check to see that all wiring is correct and enclosed to prevent possible shock.
3)Check to ensure there are no gas leaks.
4)Make sure the glass in the door frame is properly positioned. Never operate the appliance with the glass removed.
5)Verify that the venting and cap are unobstructed.
6)Ensure that the brick panels are installed.
7)Verify log placement. If the pilot cannot be seen when lighting the unit, the logs have been incorrectly positioned.
8)The unit should never be turned off, and on again without a minimum of a 60 second wait.
DO NOT BURN THE APPLIANCE WITHOUT THE GLASS FRONT IN PLACE.
DO NOT ATTEMPT TO CLEAN THE GLASS WHILE IT IS STILL HOT!
During the first few fires, a white film may develop on the glass front as part of the curing process. The glass should be cleaned after the unit has cooled down or the film will bake on and become very difficult to remove. Use a
LIGHTING
PROCEDURE
1)Plug the power cord into a power outlet.
2)Press and release the ON/OFF button once on the Remote Control.
3)After approximately 3 seconds the spark ignition system will spark for 30 seconds to light the main burner.
OPERATION
4.Once it is successfully transmitted, wait for 20 seconds and press the ON/OFF button on the remote control once and the burners will come on.
If is does not work the fi rst time, repeat steps 2 and 3.
5.The remote control is now programmed to the receiver and the appliance can now be operated with it.
The control box will only learn the Remote ID codes during the fi rst 30 seconds after power is applied and will ignore this special command from the Remote after the fi rst 30 seconds.
NOTE: This must only be performed by a quali- fi ed installer.
FIRST FIRE
The FIRST FIRE in your heater is part of the paint curing process. To ensure the paint is properly cured,it is recommendedyou burnyourfireplace for at least four (4) hours the fi rst time.
When fi rst operated, the unit will release an odour caused by the curing of the paint and the burning off of any oils remaining from manufac- turing. Smoke detectors in the house may go off at this time. Open a few windows to ventilate the room for a couple of hours. The glass may require cleaning.
NOTE: The main burner will always start on "HIGH" and resume it's last setting after 20 seconds of operation.
NOTE: When the glass is cold and the appliance is lit, it may cause condensation and fog the glass. This condensation is normal and will disappear in a few minutes as the glass heats up.
4)The unit will turn on.
NOTE:
If the unit does not turn on within 90 seconds of pressing the ON/OFF button on the Remote Control, this means that the system is in lockout mode.
The unit will need to be reset as follows;
a)Remove the left side exterior brick panel.
b)Hold the reset button for 3 to 5 seconds or until the LED stops blinking.
c)Repeat step 2.
Note:Forcompleteremotecontrolfunctionality refer to the Fire Wizard manual.
SHUTDOWN
PROCEDURE
1)Press and release the ON/OFF button once on the Remote Control.
2)If service is to be preformed, you must disconnect both sources of power to the unit; main power and the battery.
Regency® L900E Direct Vent Gas Fireplace | 33 |
