MAINTENANCE

4)Disconnect both sources of power; the power cord, located on the 7) Disconnect the spark cable and valve sensor wires from the control

left hand side of the fi rebox and the wires connected to the back-up

board.

battery located on the right side of the fi rebox.

 

 

Backup

Power

 

Battery

 

Receptacle

 

 

 

MAINTENANCE

5)Remove the control box by carefully lifting off the velcro and sliding it out from the side of the fi rebox.

6)Disconnect the wire harnesses from the control board labelled A, C, D, E & F. Do not disconnect the the jumper cables labelled B.

F

8)Remove the cable tie from control box to release the wires. Do not discard cable tie.

9)Remove the Ground screw from the control box.

10)Replace the control box.

11)Reverse steps 9 to 1. When re-connecting wire harnesses. Ensure that the cables match the letters labelled on the control box and are securely connected.

A C D E

Jumper Cable 'B'

DO NOT REMOVE

38

Regency® L900E Direct Vent Gas Fireplace

Page 38
Image 38
Regency L900E-NG installation manual Do not Remove