INSTALLATION
BAY LOUVERS
1)Install top louver by sliding the two bracket clips into the brackets located on top of the bay door. See below. The fitted louver leaves a small gap between faceplate bot- tom and louver top.
5)Open the bottom louver. Pull the Burner ON/ OFF control box from inside the bottom of the fireplace and position the slots in the bracket over the 2 screws on the left side of the bottom louver. Push down to lock into place. Tighten the screws.
Burner ON/OFF
control box
Screws on louver
bracket
OPTIONAL
WALL THERMOSTAT
OPTIONAL
REMOTE CONTROL
Use the Regency Remote Control Kit approved for this unit. Use of other systems may void your warranty.
The remote control kit comes with a hand held transmitter, a receiver and a wall mounting plate.
1)Choose a convenient location on the wall to install the receiver and the receptacle box (protection from extreme heat is very important). Run wires from the fireplace to that location. Use Thermostat Wire Table.
2)Connect the two wires to the gas valve. See diagram below.
CAUTION
Do not wire millivolt remote control wires to 120V wire.
2)Install bottom louver by sliding the two bracket clips into the brackets located un- derneath the bay door. Secure with 1 screw into each Bottom Louver Mounting Bracket as per diagram below. Use the bottom hole in the bracket.
3)Slide the valve extension knobs onto the valve knobs. Match the correct ext. knob with the valve knob.
A wall thermostat may be installed if desired, connect the wires as per the wiring diagram. Use table below to determine the maximum wire length.
Note: Preferable if the thermostat is in- stalled on an interior wall.
Regency offers an optional programmable ther- mostat but any
CAUTION
Do not wire millivolt wall thermostat wires to 120V wire.
Thermostat Wire Table
Recommended Maximum Lead Length
Thermostat
Wire Size | Max. Length |
|
14 GA. | 50 Ft. |
|
16 GA. | 32 Ft. |
|
18 GA. | 20 Ft. |
|
20 GA. | 12 Ft. |
|
22 GA. | 9 Ft. |
|
|
|
|
3)Install 3 AAA alkaline batteries in transmit- ter and 4 AA alkaline batteries in the receiver. Install the receiver and its cover in the wall. Switch the remote receiver to "remote" mode. The remote control is now ready for operation.
OPTIONAL
WALL SWITCH
1)Run the supplied 15' of wire through the right or left side gas inlet opening. Be careful not to damage wire.
Note: We recommend a maximum of 15' of wire but if you wish to go with a longer run, use the Thermostat Wire Table.
2)Connect the wire to the supplied wall switch and install into the receptacle box.
CAUTION
Do not wire millivolt
wall switch wire
to 120V wire.
Regency | 25 |
