Regency P33R-LP2, P33R-NG2 installation manual Optional Brick Panels, LOG SET Installation

INSTALLATION

OPTIONAL BRICK

PANELS

1)Undo the bottom 2 door latches and open and remove glass door. Remove logs.

2)Attach the 2 Rear Brick Retaining clips to the rear wall. Loosen the screws in the top and rear wall of the firebox and slide the retaining clips into position (tight against the firebox top) and then tighten the screws.

LOG SET INSTALLATION

Read the instructions below carefully and refer to the dia- grams. If logs are broken do not use the unit until they are replaced. Broken logs can in- terfere with the pilot operation.

The "02" refer

numbers (i.e. 02-57) are molded into the rear of each log.

Note: The logs must not be in the unit.

3)Insert the back brick panel by carefully slipping it between the back wall of the firebox and the rear log bracket.

4) Put the side panels in next. Slide them in from

the front and push them flat up against the

wall. Be very careful not to scratch them on

the firebox hardware.

The gas log kit (Part # 431-930) contains the following pieces:

A)	02-57	Rear Log	902-250
B)	02-61	Middle Cross Log	902-254
C)	02-60	Front Left Cross Log	902-253
D)	02-58	Rear Left Log	902-251
E)	02-59	Front Right Cross Log	902-252
F)		Embers	902-156
G)		Vermiculite	902-179/21

NOTE: If you will be installing the optional Brick Panels, install the Brick Pan- els prior to installing the logs.

1)Carefully remove the logs from the box and unwrap them. The logs are fragile, handle with care - do not force into position.

2)Sprinkle the vermiculite around the firebox base.

4)Place Log B) 02-61 on the front right side of the burner. Push the back of the log against the 2 brackets with the notch on the bottom right side of the log fitting into the right side of the grate.

Notch

B) 02-61

BracketBracket

A) 02-57

B) 02-61

5)Slide the Top Brick Panel into position and slide the Top Brick Retaining clips so that they hold the Top Brick Panel in place and tighten down the screws.

5) Position Log C) 02-60 across the cutouts in Logs A) 02-57 and B) 02-61 with the notch on the left side of the log fitting into the 2nd

Vermiculite	Vermiculite	Vermiculite	grate tab.
			Cutouts

3)Place the Log A) 02-57 on the rear log support pins with the flat side to the back.

C) 02-60

A) 02-57

A) 02-57

B) 02-61

2nd Grate Tab

22 Regency P33R-2 Zero Clearance Rear Vent Direct Vent Gas Fireplace