Chapter 2 Installing the SN 5428 Storage Router

Installing the SN 5428 Chassis

Installing the SN 5428 Chassis

You can install the SN 5428 chassis on a table or a shelf, or in an equipment rack. The following sections describe the steps required to install the SN 5428 chassis:

Installing on a Table or a Shelf, page 2-6

Rack-Mounting the SN 5428 Storage Router, page 2-7

Attaching the Optional Cable Guide, page 2-10

Before installing the storage router, read the Site Preparation and Safety Guide to familiarize yourself with proper site and environmental conditions.

Installing on a Table or a Shelf

You can install the SN 5428 Storage Router chassis on a table or a shelf (or another flat, secure surface).

If you are going to install the SN 5428 Storage Router in an equipment rack, skip this section and proceed to the “Rack-Mounting the SN 5428 Storage Router” section on page 2-7. To install the chassis on a table or a shelf, follow these steps:

Step 1 Locate the four adhesive-backed rubber feet. They are in the accessory kit that is shipped with the storage router.

Step 2 Peel the rubber feet from their backing and place the feet, adhesive-side down, onto the four round recessed areas on the bottom of the chassis.

Step 3 Place the storage router on a table or a shelf near an AC power source.

 

Cisco SN 5428 Storage Router Hardware Installation Guide

2-6

OL-4796-01

Page 32
Image 32
Cisco Systems manual Installing the SN 5428 Chassis, Installing on a Table or a Shelf