Chapter 1 Product Overview

Front-Panel LEDs

Fibre Channel Ports

The Fibre Channel ports are labeled FC 1 through FC 8. (See Figure 1-3.) Each port provides a 1-Gigabit/2-Gigabit autosensing Fibre Channel interface for connecting to storage systems, Fibre Channel switches, Fibre Channel hosts, or other Cisco storage networking products. Each Fibre Channel port can be configured as one of the following port types: G_Port, GL_Port, F_Port, FL_Port, or TL_Port. Each port uses a small form-factor pluggable (SFP) module for connection to the port’s physical medium. See Appendix B, “Cable and Port Pinouts” for SFP module specifications. Each Fibre Channel port has LEDs indicating its status, as described in the “Front-Panel LEDs” section.

The storage router contains two internal Fibre Channel interfaces to allow access between the GE ports and the Fibre Channel ports, FC 1 through FC 8. These two internal Fibre Channel interfaces are named fci1 and fci2. As Fibre Channel initiators, these interfaces are assigned World Wide Port Numbers (WWPN); therefore, fci1 is also referred to as initiator WWPN1 and fci2 is also referred to as initiator WWPN2. There are no hardware installation tasks for these interfaces; however, it is important to be aware of this internal architecture and the WWPNs for some software configuration tasks that required these port WWPNs (i.e. zoning).

Front-Panel LEDs

The front-panel LEDs provide status indications about the SN 5428 chassis and its ports. (See Figure 1-4.)

Each Gigabit Ethernet port, GE 1 and GE 2, has three LEDs, labeled LINK, TX, and RX. The LEDs are located to the left of each Gigabit Ethernet port.

The FAULT, STATUS, and POWER LEDs indicate the overall status of the

SN 5428 Storage Router. The LEDs are located to the left of the CONSOLE port.

The 10/100 Ethernet management port, MGMT 10/100, has two LEDs, labeled ACT and SPEED. The ACT LED is located at the left-bottom corner of the port; the SPEED LED is located at the right-bottom corner of the port.

The 10/100 Ethernet HA port, HA 10/100, has two LEDs, labeled ACT and SPEED. The ACT LED is located at the left-bottom corner of the port; the SPEED LED is located at the right-bottom corner of the port.

 

 

Cisco SN 5428 Storage Router Hardware Installation Guide

 

 

 

 

 

 

OL-4796-01

 

 

1-5

 

 

 

Page 21
Image 21
Cisco Systems SN 5428 manual Front-Panel LEDs, Fibre Channel Ports