Renesas M3A-HS71, SH7670 Before Using the SH7670 CPU Board , 1.5 Items to Be Prepared by User

Before Using the SH7670 CPU Board

1.5 Items to Be Prepared by User

Rev. 1.01 May 7, 2008 1-5

REJ11J0015-0101

1.5 Items to Be Prepared by User

The following lists the items that need to be prepared by users separately from this product.

You need to prepare the following power supply separately from the product package in order to supply power to the

SH7670 CPU board.

Table 1.5.1 Items to Be Prepared by User (For SH7670 CPU board)

No. Item to Be Prepared by User Remark

1 5 V DC output stabilizing power supply 1.5 A or more

The installation described here uses the tools made by Renesas.

To use this product following the installation, you need to prepare some items separately from the product package.

The table below lists the tools made by Renesas that users should prepare.

Table 1.5.2 Items to Be Prepared by User (Renesas Tools)

No. Item to Be Prepared by User Product Type Name Applicable Version

2 E10A-USB emulator for the SuperH family HS0005KCU02H or

HS0005KCU01H One that supports the SH-2A

3 SuperH RISC engine C/C++ compiler package R0C40700XSW09R Ver.9.00 release01 or more

4 Integrated development environment tool,

HEW (High-performance Embedded Workshop) - Ver.4.03.00 or more

Notes:

• If you already have the E10A-USB emulator main unit and are using any device group other than the SH-2A group,

you need to purchase an “additional device group license tool” separately from the product package.

• For details on how to set up a new device group in the E10A-USB emulator, refer to Section 3.2.2, “Setting Up the

E10A-USB Emulator” in Chapter 3 of this manual.

To use the above Renesas tools, we recommend using the host computer and the OS version listed in Table 1.5.3

below.

Table 1.5.3 Operating Environment for the Renesas Development Tools

Host Computer

Specification IBM PC/AT Series and Compatibles

CPU IBM PC and its compatible incorporating Pentium III or later (600 MHz or greater

recommended) and USB 1.1/2.0 (Full Speed)

Memory 128 MB or more (at least twice the load module size recommended)

Hard disk capacity

Installation requires 100 MB or more of hard disk capacity.

(With the swap area taken into consideration, at least twice the memory size must be

available (four times or more recommended).)

OS Windows 2000, WindowsXP