Getting started
Connecting and switching on the display
Connecting the display
(for an overview of the connection sockets see the illustration on page 6)
. Plug the mains power cord into the mains input jack on the plasma TV and the mains plug into a plug receptacle.
Cable connection / terrestrial aerial
If you would like to connect a cable, a terrestrial aerial or a satellite recei- ver, use the ANTENNA socket for this purpose.
Video recorder / DVD player / satellite receiver
If you receive your TV channels via satellite, connect your receiver by means of a SCART cable to the SCART 1 or SCART 2 socket.
In addition, SCART 1 has a connection socket for RGB sources, e.g. a DVD player.
Only a SCART 2 can be used for connecting a decoder.
DVD player
For connection of a DVD player or another video source to a
If your DVD player has a
f a DVD player is connected to the
D Before you make a connection between the DVD player and the display screen using the cables, you must disconnect
the mains plug of the DVD player from the plug socket.
D Once the cables are plugged in on the DVD player and on the display screen, the mains plug of the DVD player can be reconnected to the mains.
If you do not comply with this procedure, damage can be caused to the DVD player or to the display screen!
Notice : If your DVD player has a HDMI interface, you use to the connec- tion the supplied adapter cable ”HDMI on DVI”.
PC
Use the PC
On older PC graphic cards it is possible that pin 9 is barred.
Should this be the case, please contact the service hotline.
10 | ENGLISH |
