Ricoh FH-P5000MP Adjusting equalizer curves, Adjusting 13-band graphic equalizer

1 Press DSP to select the graphic equali-
zer.
Press DSP until PWRFL appears in the display.
#If the graphic equalizer has been previously
set to an equalizer curve other than PWRFL then
the title of that previously selected equalizer
curve will be displayed instead of PWRFL.
2 Push Multi Control left or right to select
an equalizer curve.
Each pushing Multi Control left or right se-
lects equalizer curves in the following order:
PWRFLNTRLVOCALFLATCTM1
CTM2S-Bas
Adjusting equalizer curves
The factory supplied equalizer curves, with the
exception of FLAT, can be adjusted to a fine
degree (nuance control).
1 Recall an equalizer curve.
See Recalling equalizer curves on the previous
page.
2 Push Multi Control up or down to ad-
just the equalizer curve.
Each pushing Multi Control up or down in-
creases or decreases the equalizer curve re-
spectively.
+6 5(or 6) is displayed as the equalizer
curve is increased or decreased.
#The actual range of the adjustments are differ-
ent depending on which equalizer curve is se-
lected.
#The equalizer curve with all frequencies set to
0cannot be adjusted.
Adjusting 13-band graphic
equalizer
For CTM1 and CTM2 equalizer curves, you
can adjust the level of each band.
!A separate CTM1 curve can be created for
each source. (The built-in CD player and
the multi-CD player are set to the same
equalizer adjustment setting automati-
cally.) If you make adjustments when a
curve other than CTM2 is selected, the
equalizer curve settings will be memorized
in CTM1.
!ACTM2 curve can be created common to
all sources. If you make adjustments when
the CTM2 curve is selected, the CTM2
curve will be updated.
1 Recall the equalizer curve you want to
adjust.
See Recalling equalizer curves on the previous
page.
2 Press DSP to select 13-band graphic
equalizer.
Press DSP until 50 appears in the display.
#If 13-band graphic equalizer has been pre-
viously adjusted, the frequency of that previously
selected will be displayed instead of 50.
3 Push Multi Control left or right to select
the equalizer band to adjust.
Each pushing Multi Control left or right se-
lects equalizer bands in the following order:
50801252003155008001.25k
2.0k3.15k5.0k8.0k12.5k (Hz)
4 Push Multi Control up or down to ad-
just the level of the equalizer band.
Each pushing Multi Control up or down in-
creases or decreases the level of the equaliza-
tion band.
+6 6is displayed as the level is increased
or decreased.
#You can then select another band and adjust
the level.
Digital Signal Processor
En 43
English
Section
10