Operating Instructions Administrator Reference
189
Protocol

Use the set command to allow/prevent remote access for each protocol.

msh> set protocol {up | down}

*1 Available when the optional 1394 Interface Unit is installed.
Note
❒If you prohibit remote access using TCP/IP and then log out, you cannot use remote access. If th is
was a mistake, you can use the control panel to allow access by TCP/IP.
❒When you prevent access via TCP/IP, you are also prevented from using ip1 394, lpr, ftp, rsh, diprint,
web, snmp and ipp.
Protocol
appletalk
tcpip
netware
netbeui
scsiprint *1
ip1394 *1
lpr
ftp
rsh
diprint
web
snmp
ipp
“up” means active and “down” means inac-
tive.