Ricoh R 3 manual Using the skew correction function, Turn the Mode Selector to Press the ! button

Using the skew correction function

1. Turn the Mode Selector to 5.

2. Press the ! button.

The still image mode selection screen appears.

3. Press the !" buttons to select [SKEW COR MODE].

4. Press the M/O button.

5. Press the shutter release button to shoot the subject.

Immediately after shooting, the area recognized as a correction range is displayed with an orange frame.

Up to five areas can be recognized.

To select another correction area, move the orange frame to the required area by pressing the $ button.

6. Press the M/O button.

The corrected image is recorded. The image before correction is also recorded.

If the target area cannot be detected, an error message appears. To cancel skew correction, press the ! button.

Even if you cancel skew correction, the image before skew correction remains recorded.

Note

•To shoot the subject as large as possible, position it so that its entire portion is seen on the LCD monitor.

•The camera may fail to recognize the subject in the following cases:

•When the image is out of focus

•When four edges of the subject are dim

•When it is hard to distinguish between the subject and background

•When the background is complicated

•Two images, one before correction and the other after correction, are recorded. If the number of remaining shots is less than 2, you cannot shoot the subject.

•If the camera fails in area detection, the image before correction remains recorded.

Quick Guide

41