Before Using the Network TWAIN Scanner

Preparing to Use the Network TWAIN Scanner

This section describes the preparations and settings for using the machine as a network TWAIN scanner.

Important

To use the network TWAIN scanner, an application that supports the scan- ner, such as DeskTopBinder Lite, must be installed on the computer. Desk- TopBinder Lite is on the supplied CD-ROM. For details about installing DeskTopBinder Lite, see “Installing DeskTopBinder Lite from the Supplied CD-ROM”.

A Connect the machine to the network.

Connect the machine to the network using an Ethernet cable or Wireless LAN (IEEE 802.11b).

B

C

Make the necessary network settings in [System Settings].

If you have connected the machine to the network using an Ethernet cable,

5

make the following settings. For details, see General Settings Guide.

 

Specify the machine’s IPv4 address and subnet mask

In [Effective Protocol], enable [IPv4]

Install the TWAIN driver on a client computer.

For details about installing the TWAIN driver, see “Installing the TWAIN Driver from the Supplied CD-ROM”.

Note

To connect the machine to network using a wireless LAN (IEEE 802.11b), an extended wireless LAN board is required respectively. For details, see Network Guide.

For details about [System Settings], see General Settings Guide.

Items to set up in [System Settings] vary depending on the network environ- ment. For details about the network settings, see General Settings Guide.

Reference

p.106 “Installing the TWAIN Driver from the Supplied CD-ROM”

p.87 “Installing DeskTopBinder Lite from the Supplied CD-ROM”

105