1210
Mounting On The No. 120 Stand
1.To
2.The stationary center leg holds a larger guide. This center leg and guide must be positioned at the REAR of the machine.
3.To mount the Model 1210 Threading Machine on the No. 120 Stand, grasp the Model 1210 machine by both the front and rear carrying handles.
4.Position the Model 1210 so the REAR of the machine is above the guide of the stationary center leg of the stand. The front corners of the machine should be above the two (2) smaller guides.
5.Lower the machine onto the mounting pins of the stand. The guides will help to properly position the machine. Insert retaining pin through hole in front guide of stand to capture machine. (Figure 3)
WARNING Before letting go of the Model 1210, be sure the stand mounting pins are properly engaged into the threading machine. Retaining pin must be prop- erly inserted before using the machine.
Figure 2 – Model 120 Stand in OPEN Position.
Figure 3 – 1210 Machine Mounted on Model 120 Stand
Machine Inspection
WARNING
To prevent serious injury, inspect your Threading Machine. The following inspection procedures should be performed on a daily basis:
1.Make sure Threading Machine is unplugged and the switch is set to the OFF position (Figure 1).
2.Clean the speed chuck jaws with a wire brush.
3.Inspect the jaw inserts for excessive wear. Refer to the Maintenance Instructions if they need to be re- placed.
4.Make sure the foot switch is present and attached to the Threading Machine (Figure 1).
WARNING Do not operate the Threading Ma- chine without a foot switch.
5.Inspect the power cord and plug for damage. If the plug has been modified, is missing the grounding pin or if the cord is damaged, do not use the Threading Machine until the cord has been replaced.
6.Inspect the Threading Machine for any broken, miss-
Ridge Tool Company | 5 |
