Rinnai IB35ETRLC, IB35ETRN installation manual To Replace Remote Control Battery

Models: IB35ETRN IB35ETRLC

1 32
Download 32 pages 19.04 Kb
Page 12
Image 12
•TO REPLACE REMOTE CONTROL BATTERY

ON BUTTON

Operates the unit

manually.

OFF BUTTON

Stops unit manually.

TEMPERATURE ADJUSTMENT Increases or decreases

the temperature

setting.

NOTE: Some fluorescent lights may interfere with the transmission of remote control signals, in this case changing the position from which you are operating the remote control may help.

Avoid getting the remote control wet, or dropping it.

The remote control works within 15 feet and an angle of 40° to the receiver on the unit.

TO REPLACE REMOTE CONTROL BATTERY

The battery is held in a clip that slides out the bottom of the remote control. The clip is removed by inserting a coin or similar into the recess in the back of the remote control and sliding downwards.

The battery must be of type CR 2032 and will only operate if installed the right way up, as shown below.

Remove the battery if the remote control is not going to be used for a long period. This will help avoid damage from leaking batteries.

REMOTE CONTROL

BACK

BATTERY

Note the + side of the battery is

facing the rear of the remote

control

12

Page 12
Image 12
Rinnai IB35ETRLC, IB35ETRN installation manual To Replace Remote Control Battery