Rinnai IB35ETRN, IB35ETRLC installation manual Location, Front

LOCATION

When positioning the heater, the main points governing the location are:

1.Flue connection and proper venting

2.Warm air distribution.

3.Adequate air supply.

4.The heater must not be installed where curtains or other combustible materials could come into contact with it. In some cases, curtains may need restraining.

See below for minimum clearances required.

	36”
12”	CEILING
LEFT
	12”
36”	RIGHT
FRONT

5.The heater is not designed to be built into bookcases or shelves or any combustible opening.

6.Check that room ventilation complies with local regulations.

7.This heater must be mounted on a hearth not less than 2” thick and at least the width and depth of the heater.

8.Installation location shall provide adequate combustion and ventilation air.

9.A gas appliance must not be connected to a chimney flue serving a separate solid-fuel burning appliance.

10.Before installing the heater, inspect the chimney, flue piping and/or solid fuel burning fire place and remove any combustible materials.

11.A zero clearance kit is available from your gas appliance retailer.

•Mantles

A mantle is allowable providing that it is outside the minimum clearances and the distance it protrudes is no more than half the distance it is above the heater.

See diagram below

•Fireplace

Cutting any sheet metal parts of the fireplace, in which the gas fireplace insert is to be installed is prohibited.

Refractory, glass doors, screen rails, screen mesh and log grates can be removed from the fireplace before installing the gas fireplace insert.

13