LOG INSTALLATION
The logset is packed inside the unit and the packaging must be removed prior to installing the logset in its correct position.
•Open both side panels.
•Remove fasteners on both sides of the top glass retainer.
•Lift retainer away from unit.
•Loosen screws on bottom glass retainer.
•Carefully lift glass out of bottom channel.
•Carefully remove log packaging.
The logset has two holes underneath for location onto the pins inside the unit.
Place the logset into the unit ensuring that the locating pins enter the two locating holes on the bottom face of the logset.
Gently place loose ember bed material in front of the front log only. Do not pour as dust particles from the plastic bag may block the burner ports.
Level it with a pencil or screwdriver and remove excess material. Note: The ember bed material must be placed after the logs are fitted. If the logs are to be removed for any reason, the ember bed material must be removed first and replaced after the logs are refitted. Any material that prevents the logs sitting flat on the burner top can upset the burning pattern and performance of the heater.
•Replace glass and top glass retainer, tighten bottom glass retainer screws.
Note: Fit glass so that the joint in the glass seal is at the bottom.
•Take care not to damage seals.
•Reinstall side panels.
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this appliance may result in property damage or personal injury.
Note: When first lighting the heater, the logs need to be burnt in, which may take approximately 2 hours. The flame color may change after the initial burning in period.
17
