30
Chapter 1 Making a Performance/Creating a Patch
The patch mode is for giving a performance. A patch is a combination of
sounds assigned to different playing surfaces and effect settings. The internal
memory can store 128 patches. No patch can be stored on any memory card.
fig.gainen
Patch Mode
To enter patch mode, press [PATCH] so it is
lit
.
Selecting a patch
Press [-]/[+] to change the patch number.
If you hold down [SHIFT] and press [-]/[+], you can change the patch number in steps of 10. If
you hold down [+] and press [-], or hold down [-] and press [+], the patch number changes
quickly.
Making sure of the memory card (CompactFlash)
When the selected patch uses a wave stored on a card,
[CARD] flashes
without the CompactFlash card inserted in the card slot of the SPD-S. In this
case, the wave sound is not reproduced.
EFFECTS
PATCH
COMMON
TRIG IN 2 WAVE A
PAD CONTROL
WAVE B
TRIG IN 1 WAVE A
PAD CONTROL
WAVE B
FOOT SW 2 WAVE A
PAD CONTROL
FOOT SW 1 WAVE A
PAD CONTROL
PAD 9 WAVE A
PAD CONTROL
WAVE B
PAD 1 WAVE A
PAD CONTROL
WAVE B
Patch 001
001
002
003
128
If you press [CARD] while it is
flashing, its light goes out
temporarily.
SPDS_e.book 30ページ ２００４年４月１９日 月曜日 午前９時５８分