Roland TD-20 owner manual Connecting Headphones, Audio Equipment, Amps, or Other Gear, Front Panel

Setting Up the Kit

Connecting Headphones, Audio Equipment, Amps, or Other Gear

Speakers with built-in amp, etc.

L

CD/MD player, etc.

R

Stereo set, etc.

An Overview of the TD-20

Rear Panel Stereo phone type Phone type

Stereo phone type

1.Turn off the power of all devices before you make connections.

*To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the power on all devices before making any connections.

2.Connect the MASTER OUT L (MONO) and R jacks on the rear panel to your audio system or amp. Headphones should ONLY be connected to the PHONES jack.

3.Connect the supplied power cord to the AC inlet.

4.Plug the power cord plug into a power outlet.

Front Panel

The TD-20’s MIX IN jack allows you to play along with a

CD or other audio sources.

•To adjust the volume of the device connected to the MIX IN jack, turn the [MIX IN] knob on the TD-20’s top panel.

•The sound input from the MIX IN jack can be output from the MASTER OUT, PHONES, or DIRECT OUT 5–8 jacks (p. 78).

*When connection cables with resistors are used, the volume level of equipment connected to the MIX IN jack may be low. If this happens, use connection cables that do not contain resistors, such as those from the Roland PCS series.

19