Section 2: Installation & Programming
21822666 2-89
SETTING UP ENHANCED AUTOPLAY
1. Set COMMAND 40, AUTOPLAY IS, to: ENH (COMMAND 41, DELAY, is not used in Enhanced
Autoplay).
2. Set COMMAND 42, START TIME, to: 00:00 (this is the factory setting).
3. Set COMMAND 43, STOP TIME, to: 23:59 (this is the factory setting).
4. Set COMMAND 44, ON DAYS, to: SMTWTFS (this is the factory setting).
5. COMMAND 45, PROGRAMMED AUTOPLAY - Programming is optional. Use Programmed Autoplay
only if you want to play specific selections or play discs in a specific order. If Programmed Autoplay is used,
it plays only those selections and discs that are listed in the play list and the discs’ categories are selected (the
category must be active and the selection must be on the play list before the selection will play).
Enhanced Autoplay looks at the selected categories first, then determines which discs may be played. If one
of the allowed category numbers matches a disc category number in the play list, that selection is played. When
you use a play list, be sure that the programmed schedule (COMMAND 49), the disc categories
(COMMAND 48), and the Programmed Autoplay selections (discs) are properly assigned, or Enhanced
Autoplay will not play the selections from the play list. See Programming Autoplay, Premiums, Priorities,
and Lockouts for information on how to program the play list.
6. Set COMMAND 47, AUTOPLAY STATUS, to: ON.
7. COMMAND 48 and 49. See Setting Up Enhanced Autoplay Schedules on the following pages.
NOTE:
COMMAND 46, CLEAR PROGRAMMED, clears all programmed selections entered in
COMMAND 45.