CD-100K Phonograph
2-2 21822666
The following steps are a summary of the detailed Power On Process that is described in Section 5 of Volume 2.
Step 1. Power switch on rear of phonograph is turned on, main power supply +9 VDC, +12 VDC, and
+24 VDC LED’s light, and all modules and components receive power. The 120~ relay closes,
supplying 120~ to the LED control and bill acceptor.
Step 2. The Voltage LED’s light on the CCC, mechanism control, KID controller, IR volume control, and title
display CBA. The Board Error LED’s on the CCC and mechanism control flash three times. The CCC
Rowelink Command, mechanism control and KID controller Rowelink TX, and IR volume control
Rowelink RCV LED’s continuously flicker.
Step 3. Phonograph is ready to operate.
LOADING CD’S AND TITLES
The procedure for loading CD’s and titles into an empty phonograph is different from the procedure to change CD’s
and titles. Please make sure you are following the procedure that describes your situation.
Preparing Titles for the Title Holder
If your titles have not been shipped with the discs or preprinted, you will need to prepare the title strips yourself.
CAUTION:
Do not attempt to turn the CD title pages by hand. If the title page assembly is unplugged
or not operating electronically, use the handwheel on the back of the assembly (see
Figure 1-2).