CD-100K Phonograph
3-4 21822666
CHANGING CD’S AND TITLES
The procedure for loading CD’s and titles into an empty phonograph is different from the procedure to change CD’s
and titles. Please be sure you are following the procedure that describes your situation.
Preparing Titles for the Title Holder - See Pages 2-2 thru 2-5
Changing Discs
You can (1) initialize each disc as you
change it, or (2) you can write down all of
the disc numbers and then type them all
into the INITIALIZE command. The
following steps describe the second
method.
Change discs as follows:
1. Unlock and open the door.
2. Pull the SERVICE switch out to
the SERVICE position (refer to
Figure 3-1).
3. Press the SCAN button to move
the disc space to the left or right of
the transfer arm.
4. Slide the old CD out of the slot and slide the new CD into the slot (see Figure 3-2) with the label to the right.
Write the disc number on a note pad.
Note that the disc positions in the molded CD magazine are identified by numbers at every other slot, with even
numbered slots labeled on one half of the magazine, and odd numbered slots labeled on the other half.
For example, on the even numbered half of the magazine, slots 00, 04, and 08 are labeled, and the slots in between
– 02 and 06 – are not, as illustrated in Figure 3-2.
NOTE:
Do not attempt to turn the CD title pages by hand. If the title page assembly is un-
plugged or not operating electronically, use the handwheel on the back of the assem-
bly (see Figure 1-2).
Slot 05
Slot 03
Slot 01
Slot 00
Slot 02
Slot 04
Odd Numbers
Even Numbers
Figure 3-2. Loading the Molded CD Magazine