Runco CL-810 / SDC-1 manual Connections to the, Connector Panel Access, System Expansion Device

Installation

3.6	Proceed as follows to connect the CL-810 to your video sources, external controller(s) -- if
Connections to the	present -- and AC power.
CL-810	When connecting your equipment:
	• Turn off all equipment before making any connections.
	• Use the correct signal cables for each source.
	• Ensure that the cables are securely connected. Tighten the thumbscrews on
	connectors that have them.
Connector Panel Access ➤	To access the connector panel, pull
	firmly on the cable access cover to
	open it.

Connecting the SDC-1➤ If (and ONLY if) your installation includes an SDC-1 System Expansion Device:

System Expansion Device	Use a Runco R-Link cable to connect the SDC-1 output to the CL-810 R-Link input; see
to the CL-810
	Figure 3-9.
	All signal sources should then be connected to the appropriate inputs on the rear panel of
	the SDC-1. The signal from the SDC-1 is then output to the CL-810 projector via the
	R-Link cable. For detailed instructions, refer to the SDC-1 Owner’s Operating Manual.
	Note	Connect ONLY an SDC-1 to the R-Link input! Although the
		R-Link looks like a DVI input, it does not function like one and
		cannot be used as an additional video input.
		R-LINK IN
		(from SDC-1 Controller
		R-Link Output to Projector
		R-Link Input)
		INPUT FROM SDC-1
		1-SDC FROM INPUT

S-VID /

VID-S

CL-810 Connector Panel

Runco International

Union City, CA

Serial No

			HD-1 INPUTS		VIDEO
	V	H	B	G	R
BOTH OUTPUTS MUST BE	HDMI / DVI
CONNECTED TO PROJECTOR
2	1

SDC-1		V	H	B	G	R	S-VIDEO
SYSTEM EXPANSION DEVICE	OUTPUTS TO	DIGITAL
	PROJECTOR	INPUTS		HD-2 INPUTS

SDC-1 Rear Panel

Figure 3-9. Connecting the CL-810 to the SDC-1

26 Runco CL-810 Series Owner’s Operating Manual